Cisco 340 Series Configuration Manual page 92

transmit power
transmit power
To configure the power at which an access point radio transmits its wireless signal, use the transmit
power command in the WiFi AP interface configuration mode.
Syntax Description percentage
Command Default
The default is 100 percent.
Command Modes WiFi AP interface configuration
Usage Guidelines For transmission of the wireless signal over a long distance, use the 100 percent setting.
For transmission of the wireless signal over a short distance, for example, when all the clients are in a
small room, lower the percentage.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-74
transmit power percentage
Percentage of transmit power. The range is from 1 to 100.
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01