Chapter 2
Configuring Local CLI - CLISH
multicast-phy-mode
To configure the PHY mode on multicast frames when an access point functions in the 802.11n mode,
use the multicast-phy-mode command in the WiFi AP interface configuration mode.
Syntax Description
0
1
2
3
Command Default
The default is 2.
Command Modes
WiFi AP interface configuration
OL-29491-01
multicast-phy-mode {0 | 1 | 2 | 3}
Specifies that the mode is disabled.
Specifies Complementary Code Keying (CCK) (802.11b).
Specifies Orthogonal Frequency Division Multiplexing (OFDM) (802.11g).
This is the default.
Specifies HTMIX (802.11b/g/n).
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
multicast-phy-mode
2-65