Ethernet Interface Configuration Mode Commands - Cisco 340 Series Configuration Manual

interface
interface
To enter the Ethernet interface configuration mode to configure the Gigabit Ethernet interface, or to enter
WiFi AP interface configuration mode to configure the wireless interface, use the interface command
in the system configuration mode.
Syntax Description ethernet ge
wireless bvi1
Command Modes
System configuration
Usage Guidelines Use the interface command to enter the Ethernet interface configuration mode or the WiFi AP interface
configuration mode.
Related Commands Use the
configuration mode.
Table 2-4 on page 2-37
Table 2-5 on page 2-46
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-26
interface {ethernet ge | wireless bvi1}
Configures the Gigabit Ethernet interface.
Configures the wireless interface.
exit command to leave the Ethernet interface configuration mode or the WiFi AP interface
lists the Ethernet interface configuration mode commands.
lists the WiFi AP interface configuration mode commands.
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01