Cisco 340 Series Configuration Manual page 97

Chapter 2 Configuring Local CLI - CLISH
encryption mode (open, shared, or WEP configuration)
To configure open, shared, or Wired Equivalency Privacy (WEP) authentication and associated
encryption for an access point, use the encryption mode command in the SSID configuration mode.
Syntax Description open
shared
none
wep
key 1
key 2
key 3
key 4
hex number
ascii phrase
Command Default The default is open access and no encryption.
Command Modes
SSID configuration
Usage Guidelines
For shared access without encryption, the WEP hexadecimal number or passphrase is used only for
authentication.
For shared access with WEP encryption, the WEP hexadecimal number or passphrase is used for both
authentication and encryption.
OL-29491-01
encryption mode {open | shared} type {none | wep {key {1 | 2 | 3 | 4} {hex number | ascii
phrase}}}
Configures open access without authentication.
Configures authentication with a shared key.
Configures no encryption.
Configures WEP encryption.
Configures the key number for WEP encryption.
(You can use only one of the four keys.)
Configures either authentication with a hexadecimal key or authentication and
encryption with a hexadecimal key:
When you select the none keyword, configures authentication with a
•
hexadecimal key.
When you select the wep keyword, configures authentication and
•
encryption with a hexadecimal key.
For number, enter either 10 or 26 hexadecimal digits.
Configures either authentication with a passphrase or authentication and
encryption with a passphrase:
When you select the none keyword, configures authentication with a
•
passphrase.
When you select the wep keyword, configures authentication and
•
encryption with a passphrase.
For phrase, enter either 5 or 13 alphanumerical characters. Dash (-) and
underscore (_) characters are supported.
encryption mode (open, shared, or WEP configuration)
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-79