Setting Up The Firewall - Toshiba GL-1010 Administrator's Manual

13 Enter the number of
14 Enter the
15 Enter the
16 Enter the
17 Click
For more information on wireless NIC settings, consult the Cisco
Aironet Wireless LAN Adapters 340 and 350 Series Quick Start Guide.
Troubleshooting
Problem
Transfer rate says "No connection"
Transfer rate says "No connection"
Transfer rate says "No connection"
There is a connection to the access point
but the printer is not visible on the network
There is a connection to the access point,
the authentication mode is
and the printer is not visible on the
network

Setting Up the Firewall

The firewall provides protection for the controller and copier from
potential malicious access via the internet. It can be used to control
access to the controller and copier from unauthorized groups and
individuals within the company as well. The firewall controls access based
on IP addresses and IP address ranges. It can operate as an exclusive list
or an inclusive list or a combination. Be careful when defining complex
access rules that you do not work against your own intentions. The
firewall does not cross-check, nor does it provide a composite list of
allowed and denied IP addresses.
You can also deny access from certain MAC addresses, effectively
preventing certain machines from accessing the controller and copier.
To setup the firewall:
1 Log in as an administrator.
2 Click the
Administrator's Guide
GL-10x0
Data Retries
Fragment Threshold
.
RTS Threshold
.
RTS Retry Limit
.
Save
Open System
tab.
Administration
.
.
Solution
Verify the access point is working
Verify SSID matches the access point
Verify WEP against the access point
Verify that the indicated settings on the
Intel card are all disabled. If it still fails,
increase the
Transmit Power Setting
Verify that the indicated settings on the
, Intel card are all disabled. If it still fails,
make sure that the
and the Access Point (AP) match.
.
of the client
WEP key
123