Sony FVS-1000 System Maintenance Manual page 45
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
(4) Connect the flat cable with the CN6027 connector on the MY-89 board.
(5) Connect the three coaxial cables with the CN402, 702 and 120 connectors on the ADC-36 board.
(6) Remove the CN-1600 board inserted between the MY-89 board and CC-78 board, and insert the DP-
345 board along the guide rail.
In the same way, remove the CN-1600 board inserted between the EN-137 board and SY-256 board,
and insert the CN-2243 board along the guide rail.
m
. When inserting the processor board, confirm the processor board name on the label.
. Insert the processor board completely until the connector is connected.
Top view
Notch
Clip plate
Screw(with stopper)
Front cover
Screw(with stopper)
(7) Connect the three coaxial cables with the CN402, 702 and 120 connectors on the ADC-36 board.
(8) Connect the flat cable with the CN6027 connector on the MY-89 board.
(9) Install the front cover, then tighten four screws.
n
Pull out the flat cable and the coaxial cables connected with the processor boards through the notch of
the front panel, then fix with the clip plate and two screws (PSW3 x 6).
FVS-1000 MMP1
Cables
Handle
Harness
band
Screw
(with stopper)
PSW3 x 6
Clip plate
Screw(with stopper)
Label
DP-345 board
CN-2243 board
Flat cable
Coaxial cables
1-11. Installation of Optional Units
CN402
CN702
CN6027
CN102
ADC-36 board
MY-89 board
1-33
Advertisement
Table of Contents
