(3) Azimuth of Slit Lens Adjustment
Measuring instruments: Oscilloscope
Tool:
Dolby Cat. No. 69P
Adjustment
1. Install the Dolby Cat. No. 69P. (Refer to Section 2-4.)
2. Set the oscilloscope to the X/Y mode, and play the
film.
3. Loosen the set screw, and turn the laser slit lens so that
the oscilloscope screen becomes as shown in Fig. 3.
Setscrew
Laser slit lens
Fig. 3
FVS-1000 MMP1
(4) Focus Adjustment
Measuring instruments: Spectrum analyzer
Tool:
Adjustment
1. Install the Dolby Cat. No. 69P. (Refer to Section 2-4.)
2. Connect the spectrum analyzer to the audio output of
FVS-T1000.
3. Perform the menu operation to set the DELAY to OFF.
Menu operation: AUDIO → MAINTENANCE →
4. Play the film, and loosen the lens adjust ring and turn
the lens adjust ring to adjust the focus of the slit lens
so that the display of the spectrum analyzer becomes
linear of _6 dB/OCT.
5. If no problems are detected in the check after adjust-
ment, apply lock compound between lens adjust ring
(B) and lens adjust ring.
After adjusting, turn OFF all switches S1 of the PRE-46
board.
NG
Lock compound
NG
OK
6-10. BKFV-500 Adjustment
Dolby Cat. No. 69P
DELAY OFF
Lens adjust ring
Lens adjust ring(B)
_6 dB/OCT
6-37