Replacing The Reel Assembly - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
4-4. Replacing the Reel Assembly
4-4. Replacing the Reel Assembly
m
. The reel table assemblies are located both T side and S side.
This section describes the replacement procedures for S reel table. The replace-
ment and adjustment procedures for the T reel table are the same.
. In the unit of the following serial numbers, when using the tools for the first time
combining the reference base assembly (J-6515-150-A) and 35GR height gauge
(J-6515-090-A), be sure to perform the height adjustments for all following guide
rollers and reel tables at the same time.
For S/T reel table height, S/T tension regulator height, GR1 through GR3 and
GR8 through GR10.
After performing the height adjustments using these tools, perform the height
adjustment for only the replaced roller guide and the roller guide considered that
there is fault.
Applicable Serial numbers: 10002, 10003, 10302 through 10304, 10401 through
10405, 10502 and 10503
Tools
. Torque wrench (For 60 kgf.cm)
. Torque driver bit (For M5)
. Reference base assembly (J-6515-150-A)
. 35GR height gauge (J-6515-090-A)
Removal
1. Removing the side and top panels
Remove the side and top panels.
(Refer to Section 2-7-1.)
2. Removing the rear panel (top)
Remove the rear panel (top).
(Refer to Section 2-7-2.)
3. Removing the door
Remove the door. (Refer to Section 2-7-3.)
4. Removing the FTP panel
. S side: FTP panels A and B
. T side: FTP panels A and C
(Refer to Section 2-7-4.)
4-6
FVS-1000 MMP1
Advertisement
Table of Contents
