Sony FVS-1000 System Maintenance Manual page 35
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
(4) Loosen the four screws (RK5 x 35), and remove the four washers for transportation.
n
Store the removed washers for transportation.
(5) Remove the 11 screws and remove the rear shield. (for UC/CE model only)
(6) Pull out the processor assembly (5 cm).
(7) Remove the connector CN3 (rear) of the processor assembly from the rear of the unit.
(8) Install the handles provided with the unit using the two screws respectively (RK5 x 14).
(9) Push in the processor assembly completely.
n
Firmly push in the two power connectors of the processor assembly to the connectors of the unit until
they connect.
(10)Connect the connector CN3 (rear) of the processor assembly from the rear of the unit.
n
Never mistake the connector to connect.
If misconnect, the unit will not make operations by system error.
(11)Secure the processor assembly with the supplied four screws (RK5 x 14) and trapezoid washers.
Trapezoid washer
RK5 x 35
Handle
FVS-1000 MMP1
Washer
Processor assembly
RK5 x 14
Handle
Trapezoid washer
RK5 x 35
Flat cable
CN3
Washer
RK5 x 14
1-10. Installation Procedure
1-23
Advertisement
Table of Contents
