Replacing The T Plate Assembly - Sony FVS-1000 System Maintenance Manual
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
4-9. Replacing the T Plate Assembly
4-9. Replacing the T Plate Assembly
Tools
. Torque wrench (For 60 kgf.cm)
. Torque driver bit (For M5)
Removal
1. Removing the static electricity
eliminator
Remove the static electricity eliminator. (It is not
necessary to remove this part for the serial
number 10701 and later.)
2. Removing the FTP panel C
Remove the FTP panel C.
(Refer to Section 2-7-4.)
3. Disconnecting the connectors
Disconnect the following connectors, and remove
the harness from the wiring stopper.
. CN1/SW-989 board
. CN1/SW-1004 board
4. Removing the T film guide
Remove the two screws, and remove the T film
guide.
5. Removing the T plate assembly
Remove the five screws, and remove the guide
plate assembly.
Installation
6. Installing the T plate assembly
Install the guide plate assembly using the five
screws.
7. Installing the T film guide
Install the T film guide using the two screws.
8. Connecting connectors
Connect the connectors disconnected at step 3.
9. Installing the FTP panel C
Install the FTP panel C removed in step 1.
(Refer to Section 2-7-4.)
10. Installing the static electricity
eliminator
Install the static electricity eliminator. (It is not
necessary to install this part for the serial number
10701 and later.)
4-24
W5
Screws
5 x 12
Screws 4 x 10
T film guide
W5
Screws
5 x 12
T plate assembly
FVS-1000 MMP1
Advertisement
Table of Contents
