Create MyConfig - Expert
4.11 Password protection
4.11.2.1
Access levels
In Expert, a CMC project is protected using three access levels with different authorization
levels. The same access levels are also applied for components. It is necessary to specifically
protect components, because components can be opened and processed independently of
projects.
You can only view protected CMC projects or protected components if you have a password
with one of these access levels.
Converted projects from older versions or newly created projects are unprotected and can be
edited as previously. You can subsequently provide projects with protection at any time.
To enter a password that permits defined processing permissions, use "Project > Password
protection > Enter password...."
Access levels
Access level
"Read project"
"Change project"
"Full access to project"
4.11.2.2
Editing a password list
Requirement
You already define the password protection when you create a project on the Package tab
under Project - General > Access (Page 137).
To make changes at a later time, e.g. activate password protection or manage the password
list, use the main menu in Expert: "Project > Password protection > Edit password list...". The
dialog "Edit password list [Rights without a password]" is opened.
If there is already password protection, then you will be initially asked to enter the password
for "Full access".
400
Authorizations
● Opening a project/component for reading
● Opening a project/component for reading
● Changing and saving a project/component
● Opening a project/component for reading
● Changing and saving a project/component
● Editing a project/component password list -
transfer password list to components
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE