Siemens SINUMERIK 840D sl Operating Manual page 383

Enumeration message level - InteractLevel
Range Enumeration
Enumeration message level - InteractLevel
Up.$Dialog.InteractLevels.
ALL
ERROR
WARNING
Enumeration installation modes - Mode
Range Enumeration
CNC software dialog - NcuSetup
Installation modes enumeration - Mode
Up.$Dialog.NcuSetup.Modes.
INSTALL
NONE
UPDATE
Enumeration source of the NC data - NcSource
Range Enumeration
System configuration dialog - SystemConfig
Enumeration, source of the NC data - NcSource
Up.$Dialog.SystemConfig.NcSources.
ARCHIVE
FACTORY
ORIGIN
UNUSED
Enumeration source of the PLC data - PlcSource
Range Enumeration
"System configuration" dialog - SystemConfig
Source of the PLC data enumeration - PlcSource
Up.$Dialog.SystemConfig.PlcSources.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Type Change effective
Enumerator value readOnly
Type
Enumerator value
Type
Enumerator value
Type
4.8 Reference list, system variables
Description
Message level, display all messages
Message level, only error messages.
Message level, error and warning mes‐
sages.
Change effective Description
readOnly Installations mode, new installation
Installation mode without installation
Installation mode upgrade
Change effective Description
readOnly The data is taken from an archive.
The NC default data is used after a
general reset.
The actual NC data at the time of pack‐
age execution is used.
Indicates to the package that this data
should not be processed.
Change effective Description
Create MyConfig - Expert
383