NEC Electra Elite 48/192 Features And Specifications Manual page 93

Issue 6
SERVICE
CONDITIONS
A - 72
Data Assignment:
Use Memory Block 1-1-04 (Automatic Redial Time Selection) to
¥
program Automatic Redial Time parameters as follows:
Programming Range
Callback Time:
Wait Time:
Redial Times:
Restrictions:
The station retains sole use of the outside line during Automatic
¥
Redial.
An internal call received during Automatic Redial cannot be
¥
answered unless Automatic Redial is released. The calling station
receives a call waiting tone.
A station user cannot set a Tone Override to a station with an
¥
Automatic Redial set. However, a Callback Request or an Automatic
Callback can be set.
This feature is not available for Single Line Telephones.
¥
This feature is not available for Tie/DID lines.
¥
General:
This feature remains in effect until the party initiating the call lifts and
¥
restores the handset or presses Speaker during a redial attempt, an
incoming call is answered on that line, or two (default) redial attempts
are made.
The system does not detect answer, no answer, or busy condition
¥
from the outside network.
When Automatic Redial is in progress (a call is being initiated by the
¥
system), an LCD appearance (
Redial is activated. For stations with or without an LCD, a flashing
Feature LED indication is provided, and the Redial key is on
continuously.
The outside line LED on the Multiline Terminal, where Automatic
¥
Redial is initiated, is green but on other Multiline Terminals in the
system it is red.
When the feature times out, access a CO/PBX line, press the
¥
Feature key and then the Redial key, or a Feature Access or One-
Touch key programmed for this feature, to reactivate it.
1~50 seconds
1~100 seconds
1~ 15 times
: Number Dialed) confirms Automatic
,
Electra Elite
Default
030
060
002
Automatic Redial