NEC Electra Elite 48/192 Features And Specifications Manual page 242

Electra Elite
SERVICE
CONDITIONS
Features and Specifications Manual
To set/cancel a CO/PBX line used for DISA at the Attendant
Position:
T
1. Press
H A
2. Dial
3. Enter the CO/PBX line number (
K K
= All Trunks
T
4. Press
Data Assignment:
Use Memory Block 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
¥
Assignment] Function No. 251 to assign a DISA Password from any
station. Up to 10 digits are allowed.
Use Memory Block 1-9-00 (DISA ID Code Assignment) to specify A
¥
DISA ID Code as 2, 3, or 4-digits that can correspond to a station
number.
Use Memory Block 1-9-02 (DISA Password Effect/Invalid Selection)
¥
to assign DISA password as valid or designate it invalid to allow
caller to use DISA without a password.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
¥
the VRS(4)-U10 ETU.
Restrictions:
DTMF signaling is required from the outside caller.
¥
Internal calls must be made before the DISA Access Code is
¥
entered.
General:
When the DISA feature is activated, the incoming outside caller
¥
hears a special tone when DISA trunks are called. These trunks can
still be used for outgoing calls.
A maximum 64 trunks for DISA can be installed in the Electra Elite
¥
192 system, or 16 trunks in the Electra Elite 48 system. Each trunk
can be programmed for Day Mode or Night Mode.
Code Restriction depends on setting a station that has a DISA ID
¥
number.
Outgoing calls using DISA cannot access LCR.
¥
.
H B
to set or to cancel.
K K
.
Issue 6
F D
~
) .
D - 33