NEC Electra Elite 48/192 Features And Specifications Manual page 427

Issue 6
SERVICE
CONDITIONS
M - 4
To respond to Message Waiting indication:
K
Dial or the associated Attendant station with the Attendant Add-On
Console used to set the message.
Call the Voice Mail System, and retrieve the messages.
Data Assignment:
Use Memory Block 1-6-05 (Attendant Add-On Console Key
¥
Selection) to assign the Message Waiting function to an Attendant
Add-On Console key.
General:
A Message Waiting indication is provided on the large LED on the
¥
recipient Multiline Terminal. Message Waiting indications from the
Attendant Add-On Console flash green; indications from a Voice Mail
Unit flash red.
To confirm a Message Waiting indication at an Attendant Add-On
¥
Console, ensure that the green LED associated with the station is on.
A Message Waiting indication remains on until the message is
canceled at the Attendant Add-On Console where it was set.
When two or more (maximum of four per system) Attendant Add-On
¥
Consoles are installed, the message is displayed only on the
Attendant Add-On Console where the setting was made.
All Attendant Add-On Consoles can be used to set a Message
¥
Waiting to the same station.
Single Line Telephones supported by an SLI(8)-U10 ETU with a
¥
Message Waiting LED receive a flashing Message Waiting indication
when set.
A Voice Mail system can set and cancel the messages to stations.
¥
Message Waiting from an Attendant Add-On Console has higher
¥
priority than Message Waiting from a Voice Mail Unit.
An Attendant Add-On Console with a Message Waiting key assigned
¥
on it cannot be used to set the Attendant Station Outgoing Lockout
feature.
Message Waiting status is retained in memory by the memory
¥
backup battery.
- OR -
Electra Elite
Message Waiting