NEC Electra Elite 48/192 Features And Specifications Manual page 102

Electra Elite
SERVICE
CONDITIONS
Features and Specifications Manual
T
4. Press
LCD). When the outgoing telephone number is longer than nine
digits, continue to press
Data Assignment:
Use Memory Block 1-4-00 (Tandem Transfer Automatic Disconnect
¥
Time Selection) to establish a disconnect time (default: 1 hour) to
release an Automatic Trunk-to-Trunk Transfer.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
¥
Selection 1] Page 1 LK7 to Allow (default: LED On) or Deny (LED
Off) set/cancel of the Automatic Trunk-to-Trunk Transfer feature by
Attendants.
Use Memory Block 3-04 (Trunk-to-Trunk Transfer Yes/No Selection)
¥
to allow (YES) or deny (default: NO) Automatic Trunk-to-Trunk
Transfer. The CO/PBX providing the outside line must provide a
timed-disconnect signal.
Use Memory Block 3-06 (Automatic Tandem Trunk Assignment) to
¥
assign the incoming and outgoing trunks to be used for Automatic
Trunk-to-Trunk Transfer.
Restrictions:
Outgoing trunks cannot be used when this feature is set.
¥
Automatic Trunk-to-Trunk Transfer and Automated Attendant cannot
¥
be set for the same trunk at the same time.
General:
When this feature is activated, and an incoming call rings in, any
¥
ringing assigned station rings and the call can be answered while the
outgoing call is being made.
The incoming or outgoing trunk can be a CO/PBX or Tie/DID line.
¥
The Attendant can press the Feature key and the line key to verify
¥
the Automatic Trunk-to-Trunk Transfer status when set.
When the outgoing line is in use and an incoming call rings in, the
¥
call is treated as a normal incoming call. When the outgoing line
becomes free, the Automatic Trunk-to-Trunk Transfer feature is
activated.
When this feature is activated, the incoming trunk LEDs assigned on
¥
Multiline Terminals wink and the outgoing trunk LEDs are always On.
(outgoing telephone number is displayed in the
T
to display each remaining digit.
Issue 6
A - 81