Table of Contents
Advertisement
Cabling instructions
Keep individual unshielded wires between the cable clamps and
the screw terminals as short as possible. Route control cables
away from power cables.
Input power (mains) cables
See sections
breakers
on page
406.
Motor cables
See section
motor cable lengths meeting the IEC/EN 61800-3 requirements
for category C2 or C3, as applicable.
The figure below shows the minimum requirements for the motor
cable shield.
Galvanised steel or tinned copper wire with braided shield.
Layer of copper tape with concentric layer of copper wire.
Concentric layer of copper wire.
28
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Input power (mains) cable, fuses and circuit
401
and
Input power (mains) cable
Motor connection
ACH550-01 User's Manual
on page
410
for the maximum
Preparing for installation
on page
Advertisement
Table of Contents
