Table of Contents
Advertisement
ACH550-01 User's Manual
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has
been verified according to standards IEC/EN 60204-
1:2005 and EN 50178:1997.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and
emissions of electrical equipment used within the European
Union. The EMC product standard IEC/EN 61800-3:2004
+A1:2012 covers requirements stated for drives.
Compliance with IEC/EN 61800-3:2004 +A1:2012
See page 445.
C-Tick marking
The ACH550 carries C-Tick marking. C-Tick marking is
required in Australia and New Zealand.
A C-Tick mark is attached to the drive to verify compliance with
the relevant standard (IEC 61800-3:2004 – Adjustable speed
electrical power drive systems – Part 3: EMC product standard
including specific test methods), mandated by the Trans-Tasman
Electromagnetic Compatibility Scheme.
The Trans-Tasman Electromagnetic Compatibility Scheme
(EMCS) was introduced by the Australian Communication
Authority (ACA) and the Radio Spectrum Management Group
(RSM) of the New Zealand Ministry of Economic Development
(NZMED) in November 2001. The aim of the scheme is to
protect the radio frequency spectrum by introducing technical
limits for emission from electrical/electronic products.
Compliance with IEC/EN 61800-3:2004
See page 445.
UL marking
The ACH550 is suitable for use on a circuit capable of
delivering not more than 100,000 rms symmetrical
amperes, 600 V maximum. The ACH550 has an
electronic motor protection feature that complies with the
requirements of UL 508C. When this feature is selected and
properly adjusted, additional overload protection is not required
unless more than one motor is connected to the drive or unless
Technical data
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
443
Advertisement
Table of Contents
