ABB ACH550-UH-011A-6 User Manual page 78

ACH550-01 User's Manual
• A bar meter instead of each signal
value.
Bottom. The bottom of the LCD
display shows:
• Lower corners – Show the functions currently assigned to the
two soft keys.
• Lower centre – Displays the current time (if configured to
show the time).
Operating the drive
AUTO/HAND – The very first time the drive is powered up, it is
in the AUTO mode (remote control), and controlled from the
Control terminal block X1.
To switch to the HAND mode (local control) and control the drive
using the control panel (operator keypad), press the HAND key
or the OFF key
• Pressing the HAND key switches the drive to local control
while keeping the drive running.
• Pressing the OFF key switches to local control and stops the
drive.
To switch back to the AUTO mode, press the
Start/Stop – To start the drive, press the HAND (
AUTO key (
Reference – To modify the reference (only possible if the display
in the upper right corner is highlighted in inverted colour) press
the UP or DOWN keys (the reference changes immediately).
The reference can be modified in the HAND mode. It can be
parameterized (using
allow modification in the AUTO mode.
Start-up and control panel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
.
). To stop the drive press the OFF key (
Group 11: REFERENCE
AUTO 15.0Hz
15. 0 Hz
3. 7 A
V 44%
00:00 MENU
key.
) or
SELECT) to also
).
73