Toro Greensmaster eFlex 1021 Service Manual page 207

Servicing the Groomer Reel (continued)
Installing the Groomer Reel
Greensmaster ® eFlex 1021
20248SL Rev A
D. When all the blades have been installed, install the second lock nut onto
the shaft. Center the blades and spacers on the shaft by adjusting the
lock nuts.
E. Use the through holes in shaft to prevent the shaft from rotating and
tighten the second lock nut to 42 to 48 N∙m (375 to 425 in-lb). After
tightening the lock nut, spacers should not be free to rotate and the
groomer blades should be centered on the shaft.
6. Install the groomer reel back onto the cutting unit; refer to
Groomer Reel (page
1. Position the groomer reel between the groomer driven and stub shafts.
2. Secure the groomer reel to the cutting unit with the 4 jam nuts, 4 bolts, and 4
shaft clamps. Tighten the bolts from 5 to 7 N∙m (45 to 60 in-lb).
3. Check the groomer reel height and mower height-of-cut settings and adjust
as necessary.
8–17).
Page 8–17 Universal Groomer (Optional): Service and Repairs
Installing the