Toro Greensmaster eFlex 1021 Service Manual page 173

Installing the Bedbar Adjuster
Greensmaster ® eFlex 1021
20248SL Rev A
1. If previously removed, secure the detent (3) to the side plate (12) with the
bolt (4).
2. If previously removed, align the key on the flange bushings (2) to the slots in
the cutting unit side plate (12) and install.
3. Slide adjuster shaft (1) into flange bushings (2) and secure with a wave
washer (5) and a retaining ring (6).
Note: The bedbar adjuster shaft (1) has left-hand threads.
4. Apply anti-seize lubricant to the threads of the bedbar adjuster screw (7)
that fit into adjuster shaft (1) (the left hand threads) and thread the bedbar
adjuster screw into the adjuster shaft.
5. Install the washer (9), compression spring (10) and lock nut (11) onto the
adjuster screw (7).
6. Install the bedbar (8); refer to Installing the Bedbar (page
Page 7–9
7–6).
DPA Cutting Units: Service and Repairs