Chapter 8: Universal Groomer (Optional) (Page - Toro Greensmaster eFlex 1021 Service Manual

Installing the Reel Assembly (continued)
Greensmaster ® eFlex 1021
20248SL Rev A
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
B. Move the pry bar against the weld side of the reel support plate closest
to the bearing lock screw.
The reel drive shaft on the left end of the cutting reel has left hand
threads. The bearing lock screw on the right end of the cutting
reel has right- hand threads.
C. Rest the handle of the pry bar against the front roller and tighten the
bearing lock screw from 123 to 149 N·m (90 to 110 ft-lb).
Do not use 1/2" extension on end of reel drive shaft when
loosening or tightening drive shaft. The 1/2" hex is intended for
backlapping only.
D. Position the pry bar in the same manner on the opposite end of the reel
and use the appropriate wrench or socket on the 1" hex portion of the
shaft to tighten the reel drive shaft from 123 to 149 N·m (90 to 110 ft-lb).
7. Install the reel drive assembly; refer to
(page 4–9). Grease the splines with high temp Mobil XHP−222 grease or
equivalent.
8. Install the bedbar assembly; refer to
9. Install the rear roller; refer to
10. Install the front roller; refer to
11. Install the cutting unit assembly to the frame assembly; refer to Operator's
Manual.
12. If the cutting unit is equipped with an optional groomer, install the components
for those options. Refer to
8–1).
IMPORTANT
IMPORTANT
IMPORTANT
Installing the Reel Drive Assembly
Installing the Bedbar (page
Installing the Rear Roller (page
Installing the Front Roller (page

Chapter 8: Universal Groomer (Optional) (page

Page 7–19
7–6).
7–23).
7–22).
DPA Cutting Units: Service and Repairs