Toro Greensmaster eFlex 1021 Service Manual page 176

Grinding the Bedknife
DPA Cutting Units: Service and Repairs
Bedknife Grinding Specifications
Standard Bedknife Relief Angle
Fairway Bedknife Relief Angle
Extended Bedknife Relief Angle
Front Angle Range
g207289
1. Top angle
2. Top surface
3. Remove burr
Since there can be variations in the mounting surface of the bedbar, it is
necessary to grind the bedknife after installing it to the bedbar. Follow
the bedknife grinding specifications provided; refer to
Specifications (page 7–12). Grind only enough so the top surface of the bedknife
is true; refer to Figure
g227152
1. Service limit (reel contacts back of bedknife scallop during operation)
2. Service limit (bottom of bedknife scallop reached when grinding)
Do not grind the bedknife below it's service limit; refer to
Operating the cutting unit with the bedknife below the service limit
may result in poor after-cut appearance and reduce the structural
integrity of the bedknife.
The bedknife service limit occurs when the reel contacts the back of the bedknife
scallop during operation. Check for reel contact marks at the back of the bedknife
scallop prior to grinding. The bedknife service limit may also occur when the
bottom of the bedknife scallop is reached when grinding the bedknife.
When grinding the bedknife, be careful to not overheat the bedknife. Remove
small amounts of material with each pass of the grinder. Also, clean and dress
grinding stone often during the grinding process.
Figure 103
4. Front surface
5. Front angle
103.
Figure 104
IMPORTANT
Page 7–12
3° minimum
3° minimum
7° minimum
13° to 17°
Bedknife Grinding
Figure
Greensmaster ®
20248SL Rev A
104.
eFlex 1021