Toro Greensmaster eFlex 1021 Service Manual page 190

Installing the Front Roller (continued)
DPA Cutting Units: Service and Repairs
4. Slide the front roller shaft (3) into the height-of-cut arm (5) attached to the
cutting unit (10).
5. Slide the remaining height-of-cut arm (5) onto the other end of roller shaft.
Secure the remaining height-of-cut arm to the side plate with a plow bolt (2),
height-of-cut washer and lock nut.
6. Center the front roller (3) in the cutting unit and tighten the pinch bolts (8) that
secure the front roller shaft to the height-of-cut arms.
7. Install the cutting unit assembly to the frame assembly; refer to Operator's
Manual, (If necessary).
8. Adjust the cutting unit height-of-cut; refer to the Cutting Unit Operator's
Manual.
Page 7–26 Greensmaster ® eFlex 1021
20248SL Rev A