Adjustments; Traction Bail Proximity Sensor - Toro Greensmaster eFlex 1021 Service Manual

Adjustments

Traction Bail Proximity Sensor

Adjusting the Traction Bail Proximity Sensor
Electrical System: Adjustments
g349622
1. Clutch bail link
2. Proximity sensor
1. Park the machine on a level surface. Ensure that the key switch is in OFF
position and the traction control is in NEUTRAL.
2. Disconnect the battery pack; refer to
(page 5–3).
3. Remove the bolts and washers that secures the control cover to the handle
assembly. Remove the control cover from the machine.
4. Get access to the proximity sensor. Pull up and release the traction bail.
5. When the bail is open, adjust the proximity sensor gap to 2.3 to 3.8 mm
(0.09 to 0.15 in).
6. If the clearance is incorrect, loosen the proximity sensor jam nuts and adjust
the clearance.
7. After achieving the required clearance, torque tighten the proximity sensor
jam nuts to 18.3 to 22.3 N·m (13.5 to 16.5 ft-lb).
8. Install the control cover to the handle assembly and secure with bolts and
washers.
9. Connect the battery pack; refer to
(page 5–3).
Figure 46
3. Jam nuts
Connecting the Lithium Battery Pack
Connecting the Lithium Battery Pack
Page 5–20 Greensmaster ® eFlex 1021
20248SL Rev A