1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the L-M Brake Release Unit. (Refer to L-M Brake Release
Unit Replacement.)
4. Remove the Reel Drive Sensor board. (Refer to Reel Drive Motor
Unit Replacement.)
5. Remove the cut washer (A) and remove the Reel Drive Cam Gear.
6. Remove the cut washer (B) and remove the MIC Drive Arm Unit.
7. Remove the cut washer (C) and remove the MIC intermittent gear.
8. Remove the cut washer (D) and remove the Reel Drive Arm Unit.
9. Remove the supply and take-up reel rotor unit. (Refer to Supply
and Take-up Reel Table Unit Replacement.)
10. Remove the cut washer (E) and remove the supply and take-up
side base drive arm unit.
11. Remove the cut washer (F) and remove the slide load.
(Installation of Slide Rod Unit)
1. Install a new Slide Rod Unit as reverse order of its removal.
2. When Reel Drive Cam Gear and MIC Intermittent Gear are installed
Slide Rod Unit Removal
Reel Drive Arm Unit Removal
77