Panasonic DVC PRO Studio AJ-D950P Service Manual page 848

3-7-13 Loading Motor Replacement
(Removal of Loading Motor)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Disconnect the connector P21 on the Mech. I/F
board. Which is shown in the Supply an Take-up
Reel Unit Replacement.
5. Remove the Pinch Solenoid Unit. (Refer to Pinch
Solenoid Replacement.)
6. Remove the screw
Emergency Shaft.
7. Remove 2 screws (C) and remove the Loading
Motor Neutral Unit.
8. Remove 2 screws (D) and remove the Loading
Motor.
(Installation of Loading Motor)
1. Install a new Loading Motor with 2 screws (D) to
the Loading Motor Neutral Unit.
2. Install the Loading Motor unit with 2 screws (C).
For this installation, be careful that the pin of
Mode SW unit should be matched to groove
position of main Cam Gear.
3. Install the emergency shaft with screw (B).
4. Install the Pinch Solenoid Unit. After installation
adjust Pinch Solenoid Position Adjustment. (Refer
to Pinch Solenoid Position Adjustment.)
5. Connect the connector P21.
(B) and remove the
Removal of Loading Motor
3-7-14. Mode Switch Unit Replacement
(Removal of Mode Switch Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Disconnect P22 on the Mech. Interconnection
board.
5. Remove the Pinch Solenoid Unit and Loading
Motor Neutral Unit. (Refer to Loading Motor
Replacement.)
6. Remove 2 screws (D) and remove the Mode
Switch Unit from the Loading Motor Neutral Unit.
(Installation of Mode Switch Unit)
1. Install a new Mode Switch Unit in reverse order of
its removal.
Note: Set the pin of the Mode Switch to the
groove of the Main Cam Gear.
2. After Pinch Solenoid Unit, adjust Pinch Solenoid
Position Adjustment. (Refer to Pinch Solenoid
Position Adjustment.)