Table of Contents
Advertisement
4. Disconnect P22 on the Mech. Interconnection board.
5. Remove the Pinch Solenoid Unit and Loading Motor Neutral Unit.
(Refer to Loading Motor Replacement.)
6. Remove 2 screws (D) and remove the Mode Switch Unit from the
Loading Motor Neutral Unit.
(Installation of Mode Switch Unit)
1. Install a new Mode Switch Unit in reverse order of its removal.
Note:
Set the pin of the Mode Switch to the groove of the Main Cam
Gear.
2. After Pinch Solenoid Unit, adjust Pinch Solenoid Position
Adjustment. (Refer to Pinch Solenoid Position Adjustment.)
5.7.15. Main Cam Gear Replacement
(Removal of Main Cam Gear)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the Pinch Solenoid Unit and Loading Motor Neutral Unit.
(Refer to Loading Motor Replacement and Pinch Arm Unit
Replacement.)
4. Remove the Main Cam Gear.
(Installation of Main Cam Gear)
1. Install a new Main Cam Gear in reverse order of its removal. For
this installation, set the pin of the Income Arm Unit to the groove
Removal of Mode Switch Unit
66
Advertisement
Chapters
Table of Contents
