Table of Contents
Advertisement
set the VFK1208 (Black , with a hole).
2. Set the VTR in the no tape loading mode.
3. Adjust the Tension Regulator Board Base Position so that the
voltage at TP201 is in the specification in STOP mode. To adjust
the Tension Regulator Board Base Position, loosen the screw A
and move the knob D portion by a screw driver without
magnetization and tighten the screw A.
4. To set the VTR in no tape loading mode, set the DIP SW1 at the
rear panel ON to open the service menu. Then select "T REEL
TRQ" and press JOG/SHTL key. During adjustment JOG/SHTL key
must be hold. Do not touch the adjustment drive to the Reel FG
magnet.
5.6.8. Tension Arm PLAY & REV Voltage Confirmation and Adjustment
Board
Specification
Test Point
Adjustment
Mode
M. EQ.
1. Set the VTR in loading completion mode, and set the VFK1156
between Tension Post and Stopper.
2. Confirm the voltage at TP201 is in the specification.
SERVO
(PLAY)3.8+/-0.05V
(REV) 1.2+/-0.3V
TP201()SERVO:F1
VR2
STOP
Digital Volt Meter.
VFK1156(Black: PLAY)
VFK1155(White: REV)
21
Advertisement
Chapters
Table of Contents
