Table of Contents
Advertisement
3-4. Manual Tape Eject
When a tape can not be ejected, because of Power
failure or mechanical tape damage, remove the tape
manually.
1.
Turns power off and remove the top panel and
front upper and front bottom panel.
2.
Release the Reel brake by pressing the iron axis
of the T Reel Brake Solenoid. This is done by a
thin stick from the VTR front.
3.
Rotate the red plastic screw by a Phillips - head
screwdriver to Counterclockwise (CCW ) keep
pushing the screw. It needs to rotate about 30
times rotation until starting to move.
4.
When the post is unloaded, the tape loosens, so
take-up reel must be wound the tape to protect
tape loosen.
The tape wind method is ; inserting a wood stick
(non magnetized) between the cassette and
mechanism chassis from the front and rotate the
T Reel to the tape wind direction.
5.
Repeat item 3 and 4 until the tape in wound
completely inside of the cassette.
6.
When the tape is completely inside of the
cassette, rotate the worm gear of the cassette
down motor and remove the cassette. Take care
so that the cassette cover does not bite the tape
when the cover is closed.
4
Rotate the T Reel and wind the tape
2
Release the T Reel Brake by pressing the solenoid.
3
6
Rotate the Gear.
Unloading the posts.
Advertisement
Chapters
Table of Contents
