- Nut Driver (5.5mm)(VFK1150)
- Hex Driver (VFK1148)
- Hex Wrench (VFK1190)
(Removal of A/C Head)
1. Remove the top panel.
2. Loosen the hex screw (B) and remove the nut (C) then hang off
the height adjustment spring (a). Remove the A/C Head Unit.
Note:
Remember the Nut (C) height before removing it.
3. Remove 2 screws (A) and remove P1 on AC HEAD I/F board and
P2030 on Mech. I/F board, then remove A/C Head.
4. Remove 2 screws (D) and remove the shield case.
5. Unsolder the Lead wire from the A/C Head. (When unsolder the
lead wires, do not unsolder all at the same time.)
55