Table of Contents
Advertisement
3-6-16. A/C Head Tilt Adjustment
No curling and bending at tape edge.
Specification
T3 Post Lower Limit
Adjustment
Screw A, G (A/C Head)
Mode
PLAY
Tape
Work Tape
Tool
VFK1148,VFK1178 (Hex Wrench)
1.
Adjust A/C Head Tilt by screw A so that the
Tape is at lower limit at T3 Post.¡
2.
For this Adjustment, loosen screw G and
make tape curling at T3 lower flange then
gradually tighten screw G to make the tape
flat. The screw G tightening torque is 1.0
Kg/cm.
(Reference)
1.
Screw A CW: Tape up
Screw A CCW: Tape down
2.
It is necessary to tighten the each
adjustment screw when the adjustment is
completed.
3.
Confirm
and
adjustment and A/C Head each adjustment
(Azimuth and Height).
adjust
alternately
this
Advertisement
Chapters
Table of Contents
