Panasonic DVC PRO Studio AJ-D950P Service Manual page 70

be parallel.
5.7.19. T1 Boat Unit Replacement
(Removal of T1 Boat Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the screw (C) and remove the T1 Post from the Loading
Rail.
4. Remove the T1 Boat Unit from the T1 Loading Arm Unit.
(Installation of T1 Boat Unit)
1. Install a new T1 Boat Unit as reverse order of its removal.
2. After its installation, confirm the T1 Post moves on the Loading
Rail. Then Linearity Adjustment is necessary.
5.7.20. T1 Loading Arm Unit Replacement and Adjustment
(Removal of T1 Loading Arm Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the cylinder unit. (Refer to the cylinder unit replacement.)
4. Rotate the emergency eject shaft CW to load the T1 Post and make
a space to remove the screw (D) as shown in Fig. 6-15-1.
5. Remove the screw (A) and (C) then remove the S1 and T1 Posts
from the Loading Rail.
6. Remove the screw (D) and (E) and remove the Loading Rail.
7. Remove the T1 Boat Unit from the T1 Loading Unit.
(Installation of T1 Loading Arm Unit)
S1 Post Loading Arm Unit Removal
70