(Adjustment Procedures)
1.
Set the Reel Table at M cassette position.
2.
Confirm the gap (A) between Brake pad and Turn
table is 0.2 mm to 0.5 mm.
3.
If the gap (A) is out of specification, loosen 2
screws and adjust brake solenoid unit as arrow
direction so that the gap is in the specification.
4.
After the above adjustment move the Reel Table
to S cassette or L cassette position and confirm
the gap is in the specification.
Brake Solenoid Position Adjustment
3-7-10 Take-up
Replacement and Adjustment
(Removal of Take-up Brake Solenoid)
1.
Remove the top panel.
2.
Remove the front loading unit.
3.
Remove the bottom panel.
4.
Remove the connector P18 on the Mech.
Interconnection board.
5.
Remove 2 screws (A) and remove the take-up
brake solenoid base unit.
6.
Remove 2 screws (B) and remove the Brake
Solenoid from the Take-up Brake Solenoid Base
Unit.
Brake
Solenoid
Take up Brake Solenoid Removal
(Installation)
1.
Install a new Take up Brake Solenoid as reverse
order of its removal.
Note:
Install a take up brake spring as shown in
the figure.
2.
After installation adjust the gap between brake
pad and turn table. (Refer to Supply Brake
Solenoid Replacement and Adjustment.)