Panasonic DVC PRO Studio AJ-D950P Service Manual page 810

.
3-6-18 A/C Head Azimuth Adjustment
Board SERVO
Specification C1,C2 : Max
Test Point TP30 (SERVO:F1)
Adjustment Screw F (A/C Head)
Mode PLAY
Tape VFM3580KM (No.1)
M. EQ. Oscilloscope
Tool VFK1148 (Hex Wrench)
1. Connect a scope to TP30 on Servo (F1)
board. Then adjust A/C Head Azimuth by
the screw F so that the CTL level is max.
2. For this Adjustment, loosen screw G and
adjust screw F then tighten screw G.
(Reference)
Confirm and adjust alternately this adjustment and
A/C Head each adjustment (Azimuth and Height).