Table of Contents
Advertisement
5.17.1 Command Syntax
Command
+CGSMS=<service>
+CGSMS?
+CGSMS=?
5.17.2 Description
The SET command is used to set the message bearer domain, namely, selection of
CS/PS domain.
The READ command returns the current message bearer domain.
The TEST command returns the supported parameter values.
5.17.3 Defined Values
<service>:
0
1
2
3
5.18 More Messages to Send +CMMS
5.18.1 Command Syntax
Command
+CMMS=[<n>]
+CMMS?
+CMMS=?
5.18.2 Description
Set command controls the continuity of SMS relay protocol link. When feature is
enabled (and supported by network) multiple messages can be sent much faster as
link is kept open.
Test command returns supported values as a compound value.
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CGSMS:<service><CR><LF><CR><LF>OK<C
R><LF>
<CR><LF>+CGSMS:
<service>s)<CR><LF><CR><LF>OK<CR><LF>
Only select the PS domain (not supported currently)
Only select the CS domain (not supported currently)
Prefer the PS domain
Prefer the CS domain
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CMMS:<n><CR><LF><CR><LF
>OK<CR><LF>
<CR><LF>+CMMS:
<n>s)<CR><LF><CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
(list
of
(list
of
supported
supported
Page 86 of 169
Advertisement
Table of Contents
