Table of Contents
Advertisement
A special SET command "%IPCGDCONT= <cid>" will clear all parameters in the
setting environment indicated by <cid>.
The READ command returns all the parameter values of the defined setting
environments. The setting environments are displayed by means of linefeed.
The TEST command returns all supported values. In the response, they are displayed
one by one by using "PDP_type" values supported by MS as index. Each entry takes
a determined PDP_type value, and includes the supported value ranges of other
parameters under the value of PDP_type. The entries are displayed by means of
linefeed.
13.12.3 Defined Values
<cid>:
1-16: Index value of PDP setting environment. Other PDP-related commands can be
used for invoking the storage position through this index value.
<PDP_type>:
String value. It indicates the type of the packet switching protocol.
"IP": IP protocol
"PPP": End-to-end protocol
"IPV6": IP protocol Version 6
<APN>:
String value. It indicates the access point domain name of the connected GGSN or
external network.
<PDP_addr>:
String value. It indicates the address of MSl.
<d_comp>:
A numerical value, controlling the compression of PDP data.
0
1
2
If no <d_comp> is included, it is equivalent to the effect that the <d_comp> is 0.
<h_comp>:
A numerical value, controlling the compression of PDP header.
0
1
2
If no <h_comp> is included, it is equivalent to the effect that the <h_comp> is 0.
Issue 18 (2009-06-22)
No compression.
Manufacturer preferred compression.
V.42BIS data compression
No compression.
Manufacturer preferred compression.
PDP header compression based on rfc 1144
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Page 139 of 169
Advertisement
Table of Contents
