Command 6: AT%IPCGDCONT?
Result 6:
%IPCGDCONT:1,"IP","vcol.com","",0,0
OK
Note: The PDP setting environment whose <cid>=16 in the MS has been cleared.
13.13 Set IP configuration parameter %IPCTRIP
13.13.1 Command Syntax
Command
%IPCTRIP=<link_id>,<type>[
,<dest_ip>[,<dest_port>[,<loc
al_port>]]]
%IPCTRIP?
%IPCTRIP=?
13.13.2 Description
This command is used to set automatic connect IP information. When set client
autoconnecting, the link_id can not be 0, the dest_ip can not be "0.0.0.0"and the
dest_port can not be 0. When set server autolistening, the link_id must be 0,the
dest_ip must be "0.0.0.0" and the dest_port must be 0.
Use " %IPCTRIP=link_id " to clear the automatic connect IP information.
13.13.3 Defined Values
<link_id>: link ID
1~5
<type>: string type, link type
Issue 18 (2009-06-22)
0
the link ID for setting server autolistening.
the range of link ID for setting client autoconnecting.
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
OK
ERROR
<CR><LF>%IPOPEN:<link_id>,<type>,<local_port
>[,<dest_ip>[,<dest_port>]]
[<CR><LF>%IPOPEN:<link_id>,<type>,<local_port
>[,<dest_ip>[,<dest_port>]]
[...]]<CR><LF><CR><LF>OK<CR><LF>
<CR><LF>%IPOPEN:(range
<link_id>s), (range of supported <type>),(range of
supported <local_port>),( range of supported
<dest_ip>),( range of supported <dest_port>)
<CR><LF><CR><LF>OK<CR><LF>
of
supported
Page 141 of 169