Table of Contents
Advertisement
Command
%IPENTRANS
13.8.2 Description
This command is used to enable TCP/UDP transparent transfer mode. In this mode
the user data is transferred to remote terminal through TCP/UDP link without length
limit.
After ">" prompt, user can input sending data continuously, Ctrl-Z is used as a send
symbol, then wait for another.
At the same time of sending data ,the terminal data will appear after "<" prompt to tell
apart.
After ">" prompt, Ctrl-Q is used as a quit symbol, firstly send all the remained data,
then disable TCP/UDP transparent transfer mode.
13.9 Register voice phone number %IPCHOSTPN
13.9.1 Command Syntax
Command
%IPCHOSTPN=<number1>
[,< number2>[,<number3>]]
% IPCHOSTPN?
13.9.2 Description
This command is used to register ipstack startup voice number and write the number
to the profile.
Use "%IPCHOSTPN = ,," to clear the register number.
13.9.3 Defined Values
<number1> : strings type, the first register voice phone number
<number2> : strings type, the second register voice phone number
<number3> : strings type, the third register voice phone number
13.10 Set autoconnecting parameter %IPCFL
13.10.1 Command Syntax
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>">"
Possible response(s)
OK
ERROR
<CR><LF>%IPINIT:<number1>[,<number2>[,<num
ber3>]]<CR><LF><CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Page 135 of 169
Advertisement
Table of Contents
