Defined Values; Unsolicited Report Of Clip +Clip; Command Syntax; Description - Huawei EM770W At Command Interface Specification

4.5.3 Defined Values

<n> (parameter sets/shows the result code presentation status to the TE):
0 disable
1 enable
<m> (parameter shows the subscriber CLIP service status in the network):
0 CLIP not provisioned
1 CLIP provisioned
2 unknown (e.g. no network, etc.)

4.6 Unsolicited report of CLIP +CLIP

4.6.1 Command Syntax

Command
+CLIP[=<n>]
+CLIP?
+CLIP=?

4.6.2 Description

An unsolicited report will be sent to TE after RING every 5 seconds if +CLIP is
enabled by the set command of CLIP.
4.6.3 Defined Values
<number>: '0' – '9', '*', '#' in the form of ASCII code value.
<type>: type of address octet in integer format. 145 means international address.
Refer to "+CMGS".
<CLI validity>:
0 CLI valid
1 CLI has been withheld by the originator.
2 CLI is not available due to interworking problems or limitations of originating network.

4.6.4 Example

<CLI validity>=0 the unsolicited report will be
+CLIP:82882690,129,,,,0
<CLI validity>=1 the unsolicited report will be
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CLIP:<n>[,<m> ]<CR><LF><CR><LF>OK<CR><
LF>
<CR><LF>+CLIP:(0,1)<CR><LF><CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Page 54 of 169