Hangup Call +Chup; Command Syntax; Description; Incoming Call Ring - Huawei EM770W At Command Interface Specification

4.3 Hangup call +CHUP

4.3.1 Command Syntax

Command
+CHUP
+CHUP=?

4.3.2 Description

Execution command causes the TA to hangup the current GSM/UMTS call of the MT.
This command will hang up all the active or hold calls but not affect the new call.

4.4 Incoming Call RING

4.4.1 Command Syntax
Command
4.4.2 Description
An unsolicited reoort will be sent to MT periodically(cycle=5s).

4.5 Calling line identification presentation +CLIP

4.5.1 Command Syntax
Command
+CLIP[=<n>]
+CLIP?
+CLIP=?
4.5.2 Description
This command refers to the GSM/UMTS supplementary service CLIP (Calling Line
Identification Presentation) that enables a called subscriber to get the calling line
identity (CLI) of the calling party when receiving a mobile terminated call. Set
command enables or disables the presentation of the CLI at the TE. It has no effect on
the execution of the supplementary service CLIP in the network.
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>OK<CR><LF>
Possible response(s)
RING
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CLIP:<n>[,<m> ]<CR><LF><CR><LF>OK<CR><
LF>
<CR><LF>+CLIP:(0,1)<CR><LF><CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Page 53 of 169