Result Code Selection And Call Progress Monitoring Control X; Command Syntax; Interface Description; Defined Values - Huawei EM770W At Command Interface Specification

3.35 Result Code Selection and Call Progress
Monitoring Control X

3.35.1 Command Syntax

Command
X[value]

3.35.2 Interface Description

The command sets whether or not the TA detects the presence of dial tone and busy
signal and whether or not TA transmits particular result codes.

3.35.3 Defined Values

<value>:
0
disabled.(default)
1
both disabled.
2
detection is disabled.
3
detection is enabled.
4
enabled.
NOTE: ATX will set value to 0.

3.36 Module Boot-up indication

3.36.1 Command Syntax
Command
3.36.2 Interface Description
When MU707 boot up, the message "EM770W READY" is reported to UART1,
MODEM interface and PC UI interface.
Issue 18 (2009-06-22)
CONNECT result code only returned, dial tone and busy detection are both
CONNECT <text> result code only returned, dial tone and busy detection are
CONNECT <text> result code returned, dial tone detection is enabled, busy
CONNECT <text> result code returned, dial tone detection is disabled, busy
CONNECT <text> result code returned, dial tone and busy detection are both
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF> ERROR<CR><LF>
Possible response(s)
EM770W READY
Page 50 of 169