Command
%IPCFL=<inde
x>,[<value>]
%IPCFL?
%IPCFL=?
13.10.2 Description
This command is used to set autoconnect parameter and write the parameter to the
profile.
13.10.3 Defined Values
<index>: parameter index
0~9:
<value>: value of parameter index
<retrycount>: This parameter is valid only in client mode.
0~10
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>%IPCFL:<retrycount>,<backoffduration>,<connection
checkmethod>,<connectioncheckperiod>,<TCPmode>,<senddel
aytime>,<MTUnumber>,<inactivitytime>,<retrytimerafterTCPfail>,
<PPPInactiveTime><CR><LF><CR><LF>OK<CR><LF>
<CR><LF>%IPCFL:
<CR><LF>[0] Retry Count (range of supported <retrycount >s)
<CR><LF>[1]
<backoffduration>s)
<CR><LF>[2] Connection Check Method (range of supported
<connectioncheckmethod>s)
<CR><LF>[3] Connection Check Period (range of supported
<connectioncheckperiod>s)
<CR><LF>[4] TCP Mode (range of supported <TCPmode>s)
<CR><LF>[5]
<senddelaytime>s)
<CR><LF>[6] MTU (range of supported <MTUnumber>s)
<CR><LF>[7]
<inactivitytime>s)
<CR><LF>[8] Retry Timer after TCP fail (range of supported
<retrytimerafterTCPfail>s)
<CR><LF>[9]
<PPPInactiveTime>s)
<CR><LF><CR><LF>OK<CR><LF>
the range of parameter index
: The times of reconnection to server after connecting failed in 10 seconds.
The defult value is 0.
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Backoff
Duration
Send
Delay
Time
Inactivity
Time
PPP
Inactive
Time
(range
of
supported
(range
of
supported
(range
of
supported
(range
of
supported
Page 136 of 169