14.2.2 Description
This command is an unsolicited report command. Used to inform user the STK card
information, then user can get the information via %STGI command.
14.2.3 Defined Values
<CmdType>: command type.
<CmdIndex>: (0-12) the index of command type
<isTimeOut>: Whether the command is timeout or not
14.3 STK Get Information %STGI
14.3.1 Command Syntax
Command
%STGI=<CmdType>,<Cmd
Index>
%STGI?
%STGI=?
Table1
Issue 18 (2009-06-22)
0
STK card has already sent a 'Setup Menu' command
1
STK card has already sent a 'Display Text' command
2
STK card has already sent a 'Get Inkey' command
3
STK card has already sent a 'Get Input' command
4
STK card has already sent a 'Setup Call' command
5
STK card has already sent a 'Play Tone' command
6
STK card has already sent a 'Sel Item' command
7
STK card has already sent a 'Refresh' command
8
STK card has already sent a 'Send SS' command
9
STK card has already sent a 'Send SMS' command
10
STK card has already sent a 'Send USSD' command
11
STK card has already sent a 'LAUNCH BROWSER' command
12
STK card has already sent a 'SET UP IDLE MODE TEXT' command
99
STK card has already sent a 'End Session' command
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Possible response(s)
Refer to Table1
+CME ERROR: <err>
%STGI:0,0
[...]
+CME ERROR: <err>
%STGI: (0-12,99)
OK
Page 146 of 169