Interface Description; Defined Values; Message List Command +Cmgl; Command Syntax - Huawei EM770W At Command Interface Specification

if pdu mode (+CMGF=0):
+CMGW=<length>[,<stat>]<
CR>PDU
given<ctrl-Z/ESC>
if text mode (+CMGF=1):
+CMGW[= <oa/da>[,<tooa
/toda>[,<stat>]]]<CR>
text is entered<ctrl-Z/ESC>
+CMGW=?

5.14.2 Interface Description

Store a message to the <mem2> storage set via the "+CPMS" command.

5.14.3 Defined Values

PDU mode:
<length>: Number of actually sent TPDU characters/2.
<mr>: Message ID. The digits are decimal numbers that range from 0 to 9. The value
range is: 0~255.
<ctrl-Z>: Identifies the end of a PDU data. The characters are: '0x1A'
<ESC>: Cancels the sending of this message. The characters are: '0x1B'
<stat>: Storage state of the message. The values are as follows: (In the PDU mode,
the default value is 0)
0
1
2
3
4
<index>: Position number in the storage. The digits are decimal numbers that range
from 0 to 9. The value range is 0~maximum capacity of storage-1.
The PDU packet structure is consistent with the description of the "+CMGS"
command.
Text mode:
<oa./da>: Originating address/Destination address. Same as defined in SCA. Total
2~12Otects. Therefore, the longest address in the OA segment contains 20 digits.

5.15 Message list command +CMGL

5.15.1 Command Syntax

Issue 18 (2009-06-22)
Unread message that has been received
Read message that has been received
Unsent message that has been stored
Sent message that has been stored
Any message (This value is only applicable to the "+CMGL" command)
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
<CR><LF>+CMGW:
<index><CR><LF><CR><LF>OK<CR><LF>
is In case of SMS-related error:
<CR><LF>+CMS ERROR: <err><CR><LF>
<CR><LF>OK<CR><LF>
AT Command Interface Specification
Page 82 of 169