Emax E2.2-E4.2-E6.2 Circuit-Breakers; Contents; Organization Of This Handbook; Intended Readership - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Emax E2.2-E4.2-E6.2 circuit-breakers

1 - Contents

Organization of this handbook This manual contains instructions on the operations to be performed on EMAX E2.2-
Intended readership This manual refers to two user profiles, as defined by standard IEC 60050:

Instructions

4 | © 2013 ABB | 1SDH001000R0002 - L7804
E4.2-E6.2 circuit-breakers throughout their life cycle, from reception to installation, and from
commissioning to subsequent maintenance during operation, with particular attention to the
environment at the end of the life cycle of the product.
Reception Installation
Figure 1
• Expert person, in the electrical area (IEV 195-04-01): Person with sufficient training and
experience to allow him/her to perceive the risks and to avoid the hazards potentially
created by electricity.
• Instructed person, in the electrical area (IEV 195-04-02): person adequately informed or
supervised by electrotechnical personnel to allow them to perceive the risks and to avoid
the hazards potentially created by electricity.
NOTE: This manual specifically indicates what operations can be performed by people
trained in the field of electricity. All the remaining operations described in the handbook
must be performed by expert persons, in the electrical area. ABB declines all liability
for damage to persons or property caused by failure to comply with the instructions
in this document.
HAZARD! RISK OF ELECTRIC SHOCK! Unplug or disconnect any power supply,
to avoid any potential risk of shock during assembly, installation, maintenance
or removal of the circuit-breaker from the service.
WARNING! Some operations must be performed when the circuit-breaker is
energized. In this case it is necessary to comply with all safety regulations.
Commissioning Maintenance
Emax E2.2-E4.2-E6.2 circuit-breakers | 1 - Contents
ABB | SACE Emax 2
Disposal