Ekip Connect Application; Ekip Bluetooth Module - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Ekip Connect application Ekip Connect is the free application for communication and testing of ABB low voltage circuit-
Ekip Bluetooth module The Ekip Bluetooth allows connection via Bluetooth between the Ekip releases, and a support
221 | © 2013 ABB | 1SDH001000R0002 - L7804
breakers equipped with compatible releases, in particular Ekip releases.
It must be installed on PCs equipped with the Microsoft Windows® operating system by
downloading it from the site http://www.abb.com/abblibrary/DownloadCenter.
With its communication function, it allows you to:
• Monitor the status of the circuit-breakers connected and record information.
• To perform operation, reset, signalling, commands etc
• Configure the protection releases with customized parameters.
• Configure the electronic accessories, connected to the release via Local Bus.
• Download information from releases equipped with Datalogger.
• Generate communication reports
• Restore configurations.
With test function, and Ekip T&P module (see page Ekip T&P module), it allows you to:
• Simulate fault conditions, by performing manual or automatic tests.
• Perform opening tests
• Generate test reports.
Further information on the Ekip Connect application is available from the web site http://www.
abb.com/abblibrary/DownloadCenter/, where the manual is available 1SDH000891R0002.
(PC, tablet, or smart phone) with the Ekip Connect application installed the (see the previous
paragraph).
IMPORTANT: the Ekip Bluetooth module can also be connected to the releases
when in service.
NOTE: Ekip Bluetooth only powers the release. Therefore, in order to set and to
display information on any electronic accessories connected to the terminal box,
these must be powered with an Ekip Supply module (see page 162).
It draws its power from a rechargeable lithium-polymer battery supplied with the unit. It is
connected directly to the front test connector of the release, and allows a release without
auxiliary voltage to be powered.
It is switched on by pressing the power button on the side, and is equipped with two LEDs:
• The first lit in green with the device on and the battery charge, red with the device turned
on and low battery.
• The second flashing blue with active Bluetooth communication.
NOTE: the red flashing LED indicates that battery is completely drained, an error
condition, or malfunction of the module.
The battery charging is performed by connecting the module to the USB ports of a PC with
the supplied cable. Connection to a PC automatically switches the module on, and charging
in progress is indicated by the flashing green LED, with increasing frequency as the level of
charging rises. Completion of charging is indicated by the green LED on (fixed).
NOTE: during recharging, the module must be kept energized.
Further information on Ekip Bluetooth is available from the web site http://www.abb.com/
abblibrary/DownloadCenter/, in particular on kit sheet 1SDH001000R0518, and in the Ekip
Connect application manual 1SDH000891R0002.
ABB | SACE Emax 2
Electronic accessories | 13 - Other accessories