Weight Of Circuit-Breakers Without Packaging; Lift The Fixed Circuit Breaker Or The Moving Part Of A Withdrawable Circuit-Breaker - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Weight of circuit-breakers
without packaging
Lift the fixed circuit breaker
or the moving part of a
withdrawable circuit-breaker
12 | © 2013 ABB | 1SDH001000R0002 - L7804
The following table specifies the weights of the circuit-breakers without packaging:
Fixed
III IV
E2.2 41 53
E4.2 56 70
E6.2 109 125
NOTE:
• the weights indicated in the table refer to the basic circuit-breakers including relays
and its sensors, without terminals and without accessories.
• the weights of the withdrawable circuit-breakers refer to the weight of the fixed part
in a version with horizontal rear terminals.
WARNING! Improper lifting can result in death, serious injury to persons and
damage to the equipment. Never lift a circuit-breaker and / or a fixed part
above other people.
IMPORTANT: The trained personnel in charge of handling and lifting must use
appropriate safety equipment.
To lift the circuit-breaker:
1. Raise the circuit-breaker from the base of the packaging with the aid of the lifting plates
supplied with the circuit-breaker. See Figure 15.
Figure 15
To raise the fixed part of the circuit-breaker
1. Raise the fixed part from the base of the packaging with the aid of the two hooks
supplied with the fixed part. See Figure 16.
IMPORTANT: keep the lifting plates for the circuit breaker, the lifting hooks
of the fixed part and the manual of the circuit-breaker until disposal.
Moving part of
withdrawable device
Fs III IV
48 55
60 74
140 120 134
Figure 16
Emax E2.2-E4.2-E6.2 circuit-breakers | 3 - Unpacking and handling
ABB | SACE Emax 2
Fixed part of
withdrawable device
Fs III IV
36 44
50 62
148 87 100
Fs
112