Access From The Display - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Access from the display With the module energized, and the Local Bus enabled, the presence of the module on the
216 | © 2013 ABB | 1SDH001000R0002 - L7804
terminal box activates additional menus on the display :
• To set the addressing of the module.
• To display information on the module.
To enable the Local Bus, you need to select "On" in the menu Settings, Modules, Local Bus.
The following table illustrates the path from the display to set addressing of the module:
...
Network frequency
Settings
Modules
Power Controller
...
The following table illustrates the parameters for setting the addressing of the modules: For
further information, see the table on page 217.
Parameter Selectable values
Force Static IP address Off, On
Displayed with static IP Address enabled, it must be selected in
Static IP Address
order to insert the IP Address of the module.
Displayed with static IP Address enabled, it must be selected in
Static Network Mask
order to insert the subnet mask of the module.
Displayed with static IP Address enabled, it must be selected
Static Gateway Address in the presence of multiple subnets, in order to insert the IP
Address of the node to which the module is connected.
The following table illustrates the path from the display for accessing information on the
modules:
Protection unit
Circuit-breaker
Information
Modules
Power Controller
Local/Remote
Local Bus
...
Force Static IP
address
Static IP Address
Ekip Link
Static Network Mask
Static Gateway
Address
...
Function
Default Description
• Off = Dynamic IP address.
Off
• On = Static IP address.
...
Ekip Link
...
Continued on the next page
Electronic accessories | 11 - Ekip Link module
ABB | SACE Emax 2