Huawei USG6000 Series Hardware Manual page 380

HUAWEI USG6000 Series
Hardware Guide
The micro SD card can be replaced no matter when the USG is powered on or off. If the USG
is powered off, skip the sd-card offline command. The following procedure guides you
through micro SD card replacement while the USG is powered on:
Before replacing the micro SD card,
l
l
l
Procedure
Step 1 Ensure that all configurations are saved.
Step 2 In the system view, run the sd-card offline command. When the system displays a message
indicating that the SD card is offline, remove the micro SD card to be replaced.
1.
2.
3.
Issue 08 (2017-06-30)
Instruments required:
– Phillips screwdriver
– ESD wrist strap
Ensure that a new micro SD card is ready.
Micro SD cards are optional and are not delivered with the device. If required, purchase
the micro SD card (part number: 06010308) from Huawei. The micro SD card model is
SDSDQAE-064G, the capacity is 64 GB, and dimensions (H x W x D) are 1 mm x 15
mm x 11 mm.
Read the precautions on using the micro SD card:
– To replace the micro SD card when the USG is powered on, you must run the sd-
card offline command in the system view first. After the system displays a message
indicating that the micro SD card is offline, remove the micro SD card. Otherwise,
the micro SD card might be damaged, and the data may be lost.
– Make sure that you have worn an ESD wrist strap and the strap is well grounded
before you hold the micro SD card. Otherwise, the micro SD card may be damaged.
NOTE
Do not use too much force; otherwise the micro SD or micro SD card slot might be damaged.
Loosen the screws on the anti-theft board and remove the anti-theft board.
Press the micro SD card along the guide rail to loosen the internal card clip. Then the
micro SD card is ejected from the slot. You can then remove the micro SD card.
Place the replaced micro SD card properly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Maintaining the Hardware
366